Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Clock

Clock

To adjust the time shown by the clock, press the "+" button or "−" button. If you press the "+" button, the indicated time will change in one-minute increments. If you press the "−" button, the indicated time will change in one-minute decrements. If you keep the button pressed, the rate at which the indicated time changes will speed up.

The clock can be set to 12-hour or 24-hour clock displays. Perform the following procedure to switch the display format.

1. Place the ignition switch in the "LOCK"/"OFF" position.

2. Press and hold the "−" button that is located near the clock display for approximately 5 seconds. The clock display will then start to flash.

3. While the clock display is flashing, press and hold the "+" button for approximately 2 seconds. The clock format will then change.

4. The clock display will continue to flash for approximately 3 seconds to inform you that the clock display has been changed.

If you want to change the clock display again, press and hold the "+" button for approximately 2 seconds while the clock display is flashing.

Turn off display of driving information display
The driving information display can be turned off. To turn off the display, turn the ignition switch to the "LOCK"/"OFF" position and press the "+" button adjacent to the clock display for appr ...

Multi information display (models with type B combination meter)
WARNING Always pay adequate attention to safe driving when operating the multi information display while the vehicle is in motion. When operation of the multi information display interferes with ...

Other materials:

Replacement of brake pad and lining
The disc brakes have audible wear indicators on the brake pads. If the brake pads wear close to their service limit, the wear indicator makes a very audible scraping noise when the brake pedal is applied. If you hear this scraping noise each time you apply the brake pedal, have the brak ...

Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor OilPROCEDURENOTE:Before making repairs, perform the oil return operation to return the compressor oil in circulation with the refrigerant to the compressor assembly.1. Increase the engine speed to 1,500 r/min.2. Turn the A/C switch to ON.3. Tu ...

Defogger setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or "  " switch to select the "Defogger" item. Then push the button. 3. The current setting will be displayed. Push the  button to enter the selection mode. 4. Select ...

© 2016-2022 Copyright www.sucross.com