Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)Inspection
MECHANICAL(H4DO) > Cylinder BlockINSPECTION1. CYLINDER BLOCK & PISTON1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sections to check for fissures.3. Check that there are no traces of gas leaking or water le ...
Inspection
WHEEL AND TIRE SYSTEM > Tire and WheelINSPECTION1. TIRECAUTION:When replacing a tire, make sure to use tires of the same size, construction and load range as originally installed.1. Tire size and tire inflation pressure check General Description > SPECIFICATION">2. Cracks, damage and ...
Assembly
BRAKE > Master CylinderASSEMBLYCAUTION:When replacing the reservoir tank, adhere the label to the position shown in the figure. (C5 model)Preparation items:C5 modelPart No.: Label (25080GA010)(a)Label(b)Brake booster 1. Install the seal to the cylinder body assembly.2. Install the reservoir tank ...