Subaru Crosstrek Service Manual: Clear memory mode Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. COMBINATION METER
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Combination Meter» and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
2. MFD
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Multi-function Display», and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing custome ...
Control module i/o signal Electrical specification
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Combination meterTerminal No.ContentTerminal No.Content1Security indicator27Ambient sensor2Charg ...
Other materials:
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) ...
Removal
EXTERIOR/INTERIOR TRIM > Side GarnishREMOVAL1. Remove the clips and detach the side garnish assembly.(1)Garnish ASSY - fender(2)Garnish ASSY - rear quarter(3)Garnish ASSY - side sill2. Remove the garnish assembly or protector on the fender panel.CAUTION:Do not reuse the garnish assembly and prote ...
Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid ValveINSPECTION1. PURGE CONTROL SOLENOID VALVE1. Check that the purge control solenoid valve has no deformation, cracks or other damages.2. Measure the resistance between the purge control solenoid valve terminals.Ter ...
