Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Clear memory mode Operation

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Clear Memory Mode

OPERATION

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Transmission Control System».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Check list for interview Check
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Check List for InterviewCHECKCheck the following items when a problem has occurred.NOTE:Use copies of this page for interviewing customers.Custome ...

Diagnostic procedure for subaru select monitor communication Communication for initializing impossible
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure for Subaru Select Monitor CommunicationCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDiagnosis:Defective harness connectorTrouble ...

Other materials:

Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearINSPECTION1. Move the reverse shifter rod toward the reverse side. Check the clearance between the reverse idler gear and the transmission case wall surface.If the value is out of specification, select the appropriate reverse shifter l ...

Dtc b1613 front sub sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1613 FRONT SUB SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of front sensor bus (RH)• Front sub sensor (RH) is fa ...

Assembly
CLUTCH SYSTEM > Operating CylinderASSEMBLYNOTE:During assembly, apply hydraulic oil to all parts.Recommended brake fluid:New FMVSS No. 116 DOT3 or DOT41. Install the piston spring.2. Insert piston into the operating cylinder.3. Install push rod to the boot.4. Install the boot and push rod. ...

© 2016-2026 Copyright www.sucross.com