Subaru Crosstrek Owners Manual: Checking the brake pedal free play
1) 0.02 - 0.11 in (0.5 - 2.7 mm)
Turn the ignition switch to the "LOCK"/ "OFF" position and firmly depress the brake pedal several times. Lightly pull the brake pedal up with one finger to check the free play with a force of less than 2 lbf (10 N, 1 kgf).
If the free play is not within proper specification, contact your SUBARU dealer.
Brake pedal
Check the brake pedal free play and
reserve distance according to the maintenance
schedule in the "Warranty and
Maintenance Booklet". ...
Checking the brake pedal reserve distance
1) More than 2.56 in (65 mm)
Depress the pedal with a force of approximately
66 lbf (294 N, 30 kgf) and measure
the distance between the upper surface of
the pedal pad and the floor.
When t ...
Other materials:
Caution
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionCAUTION1. Airbag system wiring harness is routed near the ECM, main relay and fuel pump relay.CAUTION:• Do not use electrical test equipment on the airbag system circuits.• Be careful not to damage the airbag system wiring harness when s ...
Electrical specification
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Models without EyeSightNOTE:• Terminal numbers in VDCCM&H/U connector (on the control module side) are shown in the figure.• When the connector is removed from the VDCCM&H/U ...
Installation
BRAKE > Front Brake PadINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly and support - front disc brake.1. Check the brake pad. Front Brake Pad > INSPECTION">2. Apply a thin coat of grease to the pad clip.Preparation items:Grease: An it ...
