Subaru Crosstrek Service Manual: Check list for interview Check
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Check List for Interview
CHECK
• Inspect the following items regarding the vehicle’s state.
• Print out this page for interviewing customers.
Blind Spot Detection/Rear Cross Traffic Alert Check List for Interview | Received Year Month Date | ||
Customer’s name | Registration No.
| Initial year of registration Year Month Date | |
Vehicle model
| Frame number
| ||
Interviewer
| Inspector
| Engine type
| Odometer reading
|
Customer specified content • • • | |||
Date when problem occurred | Year Month Date | Frequency of trouble occurrence | Always occurs Sometimes occurs ( times per day, times per month) |
Condition of trouble occurrence (How the trouble occurs) |
| Weather | Fine • Cloudy • Rainy • Snowy • Others ( ) |
Temperature | °C (°F) — °C (°F) | ||
Road conditions |
| Occurrence location |
|
Accessory installation condition |
| ||
Confirmation of trouble condition |
| ||
Diagnostic Trouble Code |
| ||
Basic diagnostic procedure Procedure
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the ...
Clear memory mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle i ...
Other materials:
Active test Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Active TestOPERATIONCAUTION:• Be sure to perform the active test while the engine is not running.• After executing the active test, execute the Clear Memory Mode.1. On «Start» display, select «Diagnosis».2. On «Vehicle selection ...
Removal
LIGHTING SYSTEM > Spot Map LightREMOVAL1. MODELS WITHOUT EyeSight1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - map.CAUTION:When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around ...
Inspection
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSPECTION1. WASHER PUMPApply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates.2. WASHER FLUID LEVEL SENSOR1. Check the connection status of washer fluid level sensor connector.2. D ...
