Subaru Crosstrek Service Manual: Check list for interview Check
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Check List for Interview
CHECK
• Inspect the following items regarding the vehicle’s state.
• Print out this page for interviewing customers.
Auto Headlight Beam Leveler System Check List for Interview Date the Vehicle is Received Year Month Day | |||
Customer’s name | Registration No.
| Initial year of registration Year Month Date | |
Vehicle model
| Frame number
| ||
Interviewer
| Inspector
| Engine type
| Odometer reading
|
Customer specified content • • • | |||
Date and time when the trouble occurred | Frequency of trouble occurrence | Always occurs Sometimes occurs ( times per day, times per month) | |
Condition of trouble occurrence (How the trouble occurs) | Weather | Fine • Cloudy • Rainy • Snowy • Others ( ) | |
Temperature | °C (°F) — °C (°F) | ||
Road conditions | Occurrence location | ||
Accessory installation condition | |||
Confirmation of trouble condition | |||
| |||
Diagnostic code
Basic diagnostic procedure Procedure
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition o ...
Clear memory mode Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information ...
Other materials:
Caution
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionCAUTION1. Airbag system wiring harness is routed near the ECM, main relay and fuel pump relay.CAUTION:• Do not use electrical test equipment on the airbag system circuits.• Be careful not to damage the airbag system wiring harness when s ...
Removal
EXTERIOR/INTERIOR TRIM > Roof MoldingREMOVALCAUTION:Be careful not to damage the body.1. Remove the roof rail assembly. (model with roof rail) Roof Rail > REMOVAL">2. Turn over the front end of the molding - roof.3. Slide the inner fastener in the direction of the arrow using a flat t ...
Disassembly
MECHANICAL(H4DO) > Cylinder BlockDISASSEMBLY1. CYLINDER BLOCK1. Remove the oil separator cover from cylinder block RH.2. Remove the liquid gasket from cylinder block RH.3. Remove the cylinder block plug (A) and the main gallery plug (B) from cylinder block RH.4. Remove the liquid gasket from the ...
