Subaru Crosstrek Service Manual: Check list for interview Check

Subaru Crosstrek Service Manual / Lan system (diagnostics) / Check list for interview Check

LAN SYSTEM (DIAGNOSTICS) > Check List for Interview

CHECK

Inspect the following item about the vehicle’s state.

1. DISPLAY STATUS IN THE COMBINATION METER

Display status in the combination meter	Engine coolant temperature gauge display	OK / NG
	Fuel gauge display	OK / NG
	Tachometer display	OK / NG (0 rpm at idling etc.)
Display of other indicators	Malfunction indicator light	ON / Blink / OFF
	Sport indicator light (AT warning light)	ON / Blink / OFF
	ABS warning light	ON / Blink / OFF
	VDC warning light	ON / Blink / OFF
	Immobilizer indicator light	ON / Blink / OFF
	AT OIL TEMP warning light	ON / Blink / OFF
	Tire pressure warning light	ON / Blink / OFF
	Engine coolant temperature warning light	Blue light ON / Red light ON / Red light blinks / Blue and red lights blink
	CRUISE indicator	ON / Blink / OFF
	Shift indicator	OK / NG
	Fuel level warning light	ON / Blink / OFF
	Airbag warning light	ON / OFF
	VDC OFF indicator	ON / OFF
	Brake warning light	ON / OFF
	Headlight beam leveler indicator	ON / OFF

2. CONDITIONS UNDER WHICH TROUBLE OCCURS

Driving condition	At standstill (While idling)
	When the vehicle is running	Vehicle speed km/h (MPH)
	While accelerating	Acceleration km/h (MPH) to km/h (MPH)
	Decelerating (With braking)	Deceleration km/h (MPH) to km/h (MPH)
	Decelerating (Without braking)	Deceleration km/h (MPH) to km/h (MPH)
	Flat road Uphill Downhill Gravel road Bumpy road Snowy road
	Does it occur when operating any part? Operated part: TROUBLE SYMPTOM:
	Are there any other troubles occurred? From where: TROUBLE SYMPTOM:

Basic diagnostic procedure Procedure

LAN SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active t ...

Clear memory mode Operation

LAN SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed» ...

Other materials:

How to use the rear view camera
When the shift lever/select lever is set to "R", the rear view camera automatically displays the rear view image from the vehicle. When the lever is set to other positions, the image before setting to "R" is displayed. 1. Set the ignition switch to "ON". 2. Set the shift lever/select leve ...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorREMOVALCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• When secondary speed sensor is removed, CVTF leaks. After ...

Dtc b27a7 trunk/rear gate internal antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A7 TRUNK/REAR GATE INTERNAL ANTENNA OPENDTC detecting condition:When open circuit occurs in the harness between keyless access CM and rear interior antenna.Trouble symptom:Ke ...