Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Check cruise indicator light and cruise set indicator light

Subaru Crosstrek Service Manual / Cruise control system (diagnostics) / Diagnostics with phenomenon / Check cruise indicator light and cruise set indicator light

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostics with Phenomenon

CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT

TROUBLE SYMPTOM:

Cruise control can be set, but the CRUISE indicator and SET indicator do not illuminate.

STEPCHECKYESNO

1.CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT.

Check the combination meter. Combination Meter System > OPERATION">

Do the CRUISE & SET indicators illuminate?

Diagnostics with Phenomenon > CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT">Go to Step 2.

Replace the meter case assembly. Combination Meter">

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is a DTC of the LAN system detected?

Perform the diagnosis according to DTC for LAN system.

Replace the ECM. Engine Control Module (ECM)">

Diagnostic procedure with phenomenon
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENONPhenomenonCheck itemReference1CRUISE switch is not turned ON. (CRUISE indicator does not illumin ...

Engine control module (ecm) i/o signal
...

Other materials:

Regarding malfunction
CAUTION Never leave or store the access key inside the vehicle or within 6.6 ft (2 m) around the vehicle (e.g., in the garage). The access key may be locked inside the vehicle, or the battery may discharge rapidly. Note that the push-button ignition switch may not turn on in some ...

Basic screen items
These are the basic screens of the multi function display. Item Information bar Fuel consumption screen ECO gauge screen (if equipped) ECO history screen Vehicle activation status screen EyeSight screen (models with the EyeSight system) Triple meter screen Guidance screen Clock/calenda ...

Removal
SECURITY AND LOCKS > Front Inner RemoteREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the screw, and remove the remote assembly - door.CAUTIO ...

© 2016-2025 Copyright www.sucross.com