Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Check adaptive cruise control indicator light/constant speed cruise control indicator light and cruise set indicator light

Subaru Crosstrek Service Manual / Eyesight (diagnostics) / Diagnostics with phenomenon / Check adaptive cruise control indicator light/constant speed cruise control indicator light and cruise set indicator light

EyeSight (DIAGNOSTICS) > Diagnostics with Phenomenon

CHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT

TROUBLE SYMPTOM:

Adaptive cruise control or conventional cruise control can be set, but adaptive cruise control indicator light/constant speed cruise control indicator light and cruise SET indicator light do not illuminate.

STEPCHECKYESNO

1.CHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT.

Check the combination meter. System Operation Check Mode > OPERATION">

Does adaptive cruise control indicator light/constant speed cruise control indicator light and cruise SET indicator light illuminate?

Diagnostics with Phenomenon > CHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT">Go to Step 2.

Replace the meter case assembly.
Combination Meter">

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault?

Perform the diagnosis according to diagnosis for LAN system.

Replace the stereo camera. Stereo Camera > REMOVAL">

Diagnostic procedure with phenomenon
EyeSight (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENON1. TEMPORARY STOP OF EyeSightPhenomenonCheck ItemReference1Temporary stop occurs frequently.EyeSight temporar ...

Ecm cancel code(s) display
...

Other materials:

Inspection
GLASS/WINDOWS/MIRRORS > Rear Regulator and Motor AssemblyINSPECTION1. Disconnect the connector of the motor - rear.2. Check the motor operation when battery voltage is applied between terminals of the motor - rear connector.• LH sideTerminal No.Inspection conditionsStandard4 (+) — 1 (&min ...

Installation
STARTING/CHARGING SYSTEMS(H4DO) > StarterINSTALLATIONInstall in the reverse order of removal.NOTE:• For CVT model, a nut is used at (a).• Tighten the starter and cable stay (b) together using the upper bolt securing the starter.Tightening torque:T1: 14 N·m (1.4 kgf-m, 10.3 ft-l ...

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Pressure with Manifold Gauge SetINSPECTION1. INSPECTION WITH PRESSURE SYMPTOMSSymptomsReferenceBoth high and low pressure sides are low. Refrigerant Pressure with Manifold Gauge Set > INSPECTION">Both high and low pressure sides ar ...

© 2016-2024 Copyright www.sucross.com