Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Certification for remote keyless entry system

Subaru Crosstrek Owners Manual / Keys and doors / Remote keyless entry system / Certification for remote keyless entry system

U.S.-spec. models

FCC ID: CWTWB1U811

FCC ID: CWTWD1U781

CAUTION

FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Canada-spec. models

Mexico-spec. models

Replacing lost transmitters
If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), your transmitters should be reprogrammed for security reasons. For details, contact your SUBA ...

Alarm system
The alarm system helps to protect your vehicle and valuables from theft. The horn sounds and the hazard warning flashers flash if someone attempts to break into your vehicle. For models with "k ...

Other materials:

Removal
SECURITY AND LOCKS > Keyless Access Indoor AntennaREMOVAL1. FRONT ANTENNA1. Disconnect the ground cable from battery. NOTE">2. Remove the cover - shift lever. Console Box > REMOVAL">3. Disconnect the connector and remove the front antenna assembly - interior.2. REAR ANTENNA1. ...

Brake booster
If the brake booster does not operate as described in the following, have it checked by your SUBARU dealer. 1. With the ignition switch in the "LOCK"/ "OFF" position, depress the brake pedal several times, applying the same pedal force each time. The distance the pedal travels should not va ...

Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0717 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock ...

© 2016-2026 Copyright www.sucross.com