WIPER AND WASHER SYSTEMS > General Description
CAUTION
• Connect the connectors and hoses securely during reassembly.
• After reassembly, make sure that the each component or each function operates normally.
• Be careful with the airbag system wiring harness which passes near electrical parts and switches.
• Be careful of the following items. Failing to do so may cause the airbag system malfunction.
– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION">
– Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
• When connecting the pipe hoses, be careful not to cause bend or blockage.
• If even a small amount of silicon oil or grease enters the tank - washer and the washer fluid passages, an oil film will be formed on the glass and will cause the wiper to chatter and judder. Make sure that no oil comes into contact with the system.
Fuel gauge
Fuel gauge (type A)
Trip knob
Fuel gauge (type B)
Trip knob (U.S.-spec. models)
Trip knob (except U.S.-spec. models)
The fuel gauge is displayed when the
ignition is in the "ON" position, and it
shows the approximate amount of fuel
remaining in the tank.
The gauge indic ...
Power window operation by passengers
Passenger's side power window switches
Each passenger window can be controlled
by the power window switch located on
the door.
Operating the windows
To open:
Press the switch down and hold it until the
window reaches the desired position.
To close:
Pull the switch up and hold it u ...
Active test Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Active TestOPERATIONCAUTION:• Be sure to perform the active test while the engine is not running.• After executing the active test, execute the Clear Memory Mode.1. On «Start» display, select «Diagnosis».2. On «Vehicle selection ...