SEAT BELT SYSTEM > General Description
CAUTION
For details of the following precautions for seat belt pretensioner, refer to “AIRBAG SYSTEM” section. General Description > CAUTION">
• Before performing vehicle maintenance, turn the ignition switch to OFF and wait for 60 seconds or more after disconnecting the negative terminal from battery. NOTE">
• The airbag system (including pretensioner) is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may operate if you do not wait for 60 seconds or more before starting the service of airbag system.
• Do not drop or apply any impact to the pretensioner.
• Do not allow oil, grease or water to come in contact with the pretensioner.
• Do not expose the pretensioner to high temperature or flame.
• Do not allow current to flow through or voltage to reach the pretensioner. Do not use a circuit tester to check resistance of the pretensioner.
• Do not disassemble or attempt to repair the pretensioner. If it is dented, cracked or deformed, replace it with a new genuine part.
• Do not use the airbag or pretensioner parts from other vehicles. Always replace parts with new genuine parts.
• When handling a seat belt with deployed pretensioner, wear gloves and goggles. Wash your hands afterwards.
• Do not reuse a seat belt with deployed pretensioner.
• Before disposal, make sure to perform an operation process to the pretensioners. Disposal of Pretensioner > PROCEDURE">
• If material from the pretensioner enters the eyes or contacts skin during operation process, wash it away with clean water, and then consult a doctor.
Electrical component location Location
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)VDC control module and hydraulic control unit (VDCCM&H/U)(7)VDC OFF indicator light(12)ABS wheel speed sensor(2)Connector(8)Steering angle sensor(13)Engine control module (ECM)(3)VDC OFF switch(9)Transmissi ...
Dtc c2122 transmitter 2 no data
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2122 TRANSMITTER 2 NO DATANOTE:Refer to DTC C2124 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2124 TRANSMITTER 4 NO DATA"> ...
Caution
LAN SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. SUPPLEMENTAL RESTRAINT SYSTEM “AIRBAG”Airbag system wiring harness is routed near the body integrated unit and twisted pair line.CAUTION:• Do not use the electrical test equipment on all airbag system wiring harnesses and c ...