Subaru Crosstrek Service Manual: Caution

Please clearly understand and adhere to the following general precautions. They must be strictly followed to avoid minor or serious injury to the person doing the work or people in the area.

1. EACH PROCEDURE

• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.

• Before disposing of shock absorbers, be sure to bleed the gas out completely. Also, do not expose to flames or fire.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.

• Use SUBARU genuine grease etc. or equivalent. Do not mix grease etc. of different grades or manufacturers.

• Before securing a part on a vise, place cushioning material such as wood blocks, aluminum plate, or cloth between the part and the vise.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• When the suspension-related components have been replaced, perform the following VDC setting mode.

– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

– Model with EyeSight: Neutral of Steering Angle Sensor & Lateral G Sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

– Model with EyeSight: Longitudinal G sensor & lateral G sensor 0 point setting VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

• Prepare container and waste cloths when performing work which oil could possibly spill. If oil spills, wipe it off immediately to prevent from penetrating into floor or flowing outside, for environmental protection.

• Follow all government regulations concerning disposal of refuse when disposing.

General description

Specification

Other materials:

Adjustment
EXTERIOR BODY PANELS > Rear GateADJUSTMENTAdjust the clearance around the panel - rear gate as follows.PartStandardAPanel - rear gate to Roof panel6.0+1.0, −0.5 mm (0.24+0.04, −0.02 in)BSurface level gap: Panel - rear gate to Roof panel1.0±1.0 mm (0.04±0.04 in)CPanel - rear gate to ...

Check list for interview Check
EyeSight (DIAGNOSTICS) > Check List for InterviewCHECKInspect the following items regarding the vehicle’s state.Writer/InspectorWriter’s name Inspector’s Name Vehicle informationCar accessory equipment conditionCar accessory is installed to the windshield glass.No/Yes(Position: ...

Dtc b28b7 ldp off switch
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28B7 LDP OFF SWITCHDetected when lane departure warning OFF switch circuit is not installed, open-circuited, or is stuck to ON.DTC detecting condition:• Wiring of lane departure warning OFF switch is not co ...