Subaru Crosstrek Service Manual: Caution

• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.

• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.

• Use grease and oil of SUBARU genuine or the equivalent products. Do not mix them of different grades or manufacturers.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• Before securing a part on a vise, place cushioning material such as wooden blocks, aluminum plate or cloth between the part and the vise.

• When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

• When the wheel alignment has been adjusted, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

General description

Specification

Other materials:

Clear memory mode Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATIONAfter repairing the occupant detection system, clear the DTCs stored in the airbag control module and the occupant detection control module.1. AIRBAG SYSTEM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» ...

Dtc b1628 side airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1628 SIDE AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (LH) an ...

Dtc c0049 cruise controller abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0049 CRUISE CONTROLLER ABNORMALDTC detecting condition:Faulty signal is received from the stereo camera.Trouble symptom:• VDC may not operate.• EyeSight does not operate.STEPCHEC ...