Subaru Crosstrek Service Manual: Caution

• Remove contamination including dirt and corrosion before removal, installation or disassembly.

• Keep the disassembled parts in order and protect them from dust and dirt.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.

• When disassembling the case and other light alloy parts, disassemble by using a plastic hammer. Do not pry apart with screwdrivers or other tools.

• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.

• Use SUBARU genuine gear oil, grease or equivalent. Do not mix gear oil, grease, etc. of different grades or manufacturers.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• Apply gear oil onto sliding or revolving surfaces before installation.

• Replace deformed or damaged snap rings with new parts.

• Before installing O-rings or oil seals, apply sufficient amount of gear oil to avoid damage and deformation.

• Be careful not to incorrectly install or fail to install O-rings, snap rings and other such parts.

• Before securing a part on a vise, place cushioning material such as wood blocks, aluminum plate, or cloth between the part and the vise.

• Avoid damaging the mating surface of the case.

• Before applying liquid gasket, completely remove and clean the old liquid gasket.

• Be careful of handling the oil seal, O-ring and gasket. If the contact surface of them is damaged, oil leakage may occur.

• When pressing-in the oil seal, make sure that the oil seal lip portion and outer surface are not damaged or tilted.

• When replacing the taper roller bearing, replace the outer race and inner race as a set.

• When replacing the hypoid gear, replace the hypoid driven gear and drive pinion shaft as a set.

• Replace the bolts if the seating surface or the thread surface is excessively rusted.

General description

Specification

Other materials:

Dtc p0138 o2 sensor circuit high voltage bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0138 O2 SENSOR CIRCUIT HIGH VOLTAGE BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...

Removal
LIGHTING SYSTEM > Front Fog Light BulbREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the screw and clips, and turn over the front side of the mud guard - front.3. From the bottom of the bumper face - front, remove the front fog light bulb.CAUTION:Use a dry clean clot ...

Preparation for overhaul Procedure
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Preparation for OverhaulPROCEDURE1. Clean oil, grease, dirt and dust from the transmission.2. When transmission gear oil remains in the transmission, using the TORX® bit T70, remove the drain plug, and drain the gear oil completely.3. Attach the drain ...