Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Caution

LUBRICATION(H4DO) > General Description

CAUTION

Prior to starting work, pay special attention to the following:

1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

2. Protect the vehicle using a seat cover, fender cover, etc.

3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.

Prepare a container and cloth when performing work which oil possibly spills. If oil spills, wipe it off immediately to prevent from penetrating into floor or flowing out for environmental protection.

Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

Keep the removed parts in order and protect them from dust and dirt.

All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.

Bolts, nuts and washers should be replaced with new parts as required.

Be sure to tighten the fasteners including bolts and nuts to the specified torque.

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.

Follow all government and local regulations concerning disposal of refuse when disposing of oil.

Always use new application oil during work.

General description
...

Specification
LUBRICATION(H4DO) > General DescriptionSPECIFICATIONLubrication methodForced lubricationOil pumpPump typeTrochoid typeNumber of teethInner rotor11Outer rotor12Outer rotor diameter ? Thicknessmm (in ...

Other materials:

Removal
CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp ...

Electrical specification
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONNOTE:The terminal numbers of the power steering control module connectors are as indicated in the figure.ContentsTerminal No.Input/output signalMeasured value and measuring conditionsPower supp ...

Operating ranges
Antenna Operating range The operating range of the door locking/ unlocking function is approximately 16 to 32 in (40 to 80 cm) from the respective door handle. The operating range of the rear gate locking/unlocking function is approximately 16 to 32 in (40 to 80 cm) from t ...

© 2016-2024 Copyright www.sucross.com