Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Caution

IMMOBILIZER (DIAGNOSTICS) > General Description

CAUTION

CAUTION:

Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.

Be careful not to damage the airbag system wiring harness.

While diagnostic items are being checked, do not operate radios, portable telephones, etc. which emit electromagnetic waves near or inside the vehicle.

When turning the ignition switch to ON or OFF while diagnostic items are being checked, do not allow keys with different ID codes close to the ignition switch. If the ignition key is on a key holder, remove it from the key holder before performing diagnoses.

When repeatedly turning the ignition switch to ON or OFF while diagnostic items are being checked, it should be switched in cycles of “ON” for at least 5 seconds > “OFF” for at least 8 seconds.

(1)

Ignition switch position

(2)

Sec.

If the engine fails to start with a registered ignition key, detach the ignition key from ignition switch and wait for approx. 1 second until security indicator light begins to flash. And then start the engine again.

Before performing the diagnostics, obtain all keys for the vehicle from the owner.

Do not register a body integrated unit already registered to another vehicle to diagnose failures or inspect functions.

General description
...

Preparation tool
IMMOBILIZER (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshoot ...

Other materials:

Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSPECTION1. MAGNET CLUTCH CLEARANCE INSPECTION1. Check the clearance of entire circumference around the drive plate and pulley.Specification:0.3 — 0.6 mm (0.0118 — 0.0236 in)2. Replace the compressor assembly if the inspection result is no ...

Installation
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyINSTALLATION1. Before installation, check the following items.• Lever is free from deformation.• Grease is applied sufficiently to lever joints.If grease is insufficient, add it as necessary before assembling.• ...

© 2016-2024 Copyright www.sucross.com