Subaru Crosstrek Service Manual: Caution

1. Never connect the battery in reverse polarity.

• Doing so may immediately damage the A/C control panel.

2. Do not disconnect the battery cables while the engine is running.

• A large counter electromotive force will be generated in the generator, and this voltage may damage electronic parts such as A/C control panel etc.

3. Before disconnecting the connectors of sensors and the A/C control panel, be sure to turn off the ignition switch.

• A/C control panel may be damaged.

4. Every A/C-related part is a precision part. Do not drop them.

5. Airbag system harness is routed near the A/C control panel and junction box.

CAUTION:

• Do not use electrical test equipment on the airbag system harness and connector.

• Be careful not to damage the airbag system harness when servicing the A/C control panel and junction box.

General description

Preparation tool

Other materials:

Dtc p013b o2 sensor slow response - lean to rich bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013B O2 SENSOR SLOW RESPONSE - LEAN TO RICH BANK 1 SENSOR 2NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESPONS ...

Component
INTAKE (INDUCTION)(H4DO) > General DescriptionCOMPONENT(1)Air intake duct(8)Air cleaner case (rear)Tightening torque: N·m (kgf-m, ft-lb)(2)Clip(9)ClipT1:1 (0.1, 0.7)(3)Cushion(10)Mass air flow and intake air temperature sensorT2:3 (0.3, 2.2)(4)Air cleaner case (front)(11)ClampT3:6 (0.6, 4. ...

EyeSight (models with EyeSight system)
NOTE For models with the EyeSight system, refer to the Owner's Manual supplement for the EyeSight system. BSD/RCTA (if equipped) After entering the "BSD/RCTA" menu, select the "Warning Volume" menu. You can set the volume of the warning buzzer for RCTA (Rear Cross Traffic Alert). You can se ...