Subaru Crosstrek Service Manual: Caution

1. AIRBAG SYSTEM

Airbag system wiring harness is routed near the cruise control command switch.

CAUTION:

• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.

• Be careful not to damage the airbag system wiring harness when servicing the cruise control command switch.

• Do not hold the camera unit of the stereo camera.

• Do not touch the lens on the stereo camera.

• Do not clean the lens of the stereo camera.

• When cleaning the windshield glass, use care so that the glass cleaner, etc. does not come in contact with the lens of the stereo camera.

• Do not make an impact or apply excessive force to the stereo camera.

• Do not disassemble the stereo camera.

• Do not change the installation position of the stereo camera or do not modify the surrounding structure.

• If the stereo camera or windshield glass is removed or replaced, always adjust or check the stereo camera.

• When lifting up the vehicle to rotate the tires, turn off the pre-crash function.

• Stereo camera axis may be displaced even in a minor collision. So be sure to adjust the stereo camera even when the EyeSight warning light is not illuminated or when the “Stereo Camera Temporary Stop” is not displayed on the multi-information display.

• When removing the stereo camera cover assembly, cover it with a copy paper or similar dust-free paper to avoid any interference to the camera lens, and tape the paper while being careful not to let the adhesive surface contact the glass surface. Be sure to remove the paper after the procedure. Stereo Camera > REMOVAL">

General description

Preparation tool

Other materials:

Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...

Dtc u0401 invalid data received from ecm/pcm a
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”DTC DETECTING CONDITION:Defective data from ECM.TROUBLE SYMPTOM:Defective data on CAN communication occurs.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNO ...

Dtc u0073 control module communication bus off
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&q ...