Subaru Crosstrek Service Manual: Caution
EXHAUST(H4DO) > General Description
CAUTION
• Prior to starting work, pay special attention to the following:
1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
2. Protect the vehicle using a seat cover, fender cover, etc.
3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.
• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.
• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.
• Keep the removed parts in order and protect them from dust and dirt.
• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.
• Bolts, nuts and washers should be replaced with new parts as required.
• Be sure to tighten the fasteners including bolts and nuts to the specified torque.
• If any grease adheres to the exhaust pipe, wipe it off. Otherwise a fire may happen.
Component
EXHAUST(H4DO) > General DescriptionCOMPONENT1. FRONT EXHAUST PIPE AND CENTER EXHAUST PIPE(1)Front exhaust pipe(12)Front exhaust pipe lower coverTightening torque: N·m (kgf-m, ft-lb)(2)Front ...
Other materials:
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxINSTALLATION1. Insert the steering gearbox assembly into crossmember, being careful not to damage the boot of the steering gearbox assembly.2. Install the steering gearbox assembly to the crossmember by tightening the bolts t ...
Diagnostic procedure with phenomenon
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENONPhenomenonCheck itemReference1CRUISE switch is not turned ON. (CRUISE indicator does not illuminate.) Or the cruise control is cancelled without CRUISE switch operation.(1) Perform cruise cancel c ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseINSTALLATION1. Clean the mating surface of extension case and transmission case.2. Select the transfer drive gear shim. Reduction Drive Gear > ADJUSTMENT">3. Select the transfer driven gear shim. Transfer Clutch > ADJUSTMEN ...
