EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General Description
CAUTION
• Prior to starting work, pay special attention to the following:
1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
2. Protect the vehicle using a seat cover, fender cover, etc.
3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.
• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.
• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.
• Keep the removed parts in order and protect them from dust and dirt.
• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.
• Bolts, nuts and washers should be replaced with new parts as required.
• Be sure to tighten the fasteners including bolts and nuts to the specified torque.
Abbreviation in wiring diagrams
WIRING SYSTEM > Basic Diagnostic ProcedureABBREVIATION IN WIRING DIAGRAMSAbbr.Full nameABSAnti-lock Brake SystemACCAccessoryA/CAir ConditionerASSYAssemblyATAutomatic TransmissionA/FAir/Fuel (air fuel ratio sensor)ATFAutomatic Transmission FluidAUXAuxiliary Audio Input TerminalAWDAll Wheel DriveB, ...
Operation
BODY CONTROL SYSTEM (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, selec ...
Average vehicle speed
U.S.-spec. models
Except U.S.-spec. models
This display shows the average vehicle
speed since the trip meter was last reset.
Trip knob
Pressing the trip knob toggles the display
between the average vehicle speed corresponding
to the A trip meter display and
the average veh ...