Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Caution

DRIVE SHAFT SYSTEM > General Description

CAUTION

When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.

Be sure to tighten fasteners including bolts and nuts to the specified torque.

Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

Apply grease onto sliding or revolving surfaces before installation.

Be sure that the surface of brake disc, brake pad or brake shoe is free from grease or oil.

Do not secure a part in a vise directly. Place cushioning materials such as wood blocks, aluminum plates, or waste cloth between the part and the vise.

When the suspension-related components have been removed or replaced, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT"> VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT"> VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

General description
...

Specification
DRIVE SHAFT SYSTEM > General DescriptionSPECIFICATION1. PROPELLER SHAFTPropeller shaft typeEDJFront propeller shaft joint-to-joint length: L1CVT675.5 mm (26.59 in)MT735.5 mm (28.96 in)Rear propelle ...

Other materials:

Driving with a trailer
You should allow for considerably more stopping distance when towing a trailer. Avoid sudden braking because it may result in skidding or jackknifing and loss of control. Avoid abrupt starts and sudden accelerations. If your vehicle has a manual transmission, always start out in ...

Removal
GLASS/WINDOWS/MIRRORS > Rear Quarter GlassREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear pillar UPR. Rear Quarter Trim > REMOVAL">3. Remove the glass - rear quarter in the same procedure as for the glass - front window. Windshield G ...

Interior light system Wiring diagram
WIRING SYSTEM > Interior Light SystemWIRING DIAGRAM1. WITHOUT EyeSight2. WITH EyeSight ...

© 2016-2024 Copyright www.sucross.com