Subaru Crosstrek Service Manual: Caution

• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing any work.

• Remove contamination including dirt and corrosion before removal, installation or disassembly.

• Keep the disassembled parts in order and protect them from dust and dirt.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.

• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or manufacturers.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• Apply grease onto sliding or revolving surfaces before installation.

• Before installing O-rings or snap rings, apply sufficient amount of fluid to avoid damage and deformation.

• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth between the part and the vise.

• Before disconnecting electrical connectors, be sure to disconnect the negative terminal from battery.

General description

Specification

Other materials:

Dtc b16f1 passenger s seat belt warning failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F1 PASSENGER’S SEAT BELT WARNING FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag control module is faulty.• Meter is faulty.• Harness circuits between ...

Removal
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">3. Remove the trim panel - front door. Door T ...

Preparation for screen settings
1. Turn the ignition switch to the "ON" position. 2. Push and hold the button to show the selection screen. 3. After the selection screen is displayed, operate the "  " or " " switch to show the "Screen Setting" item. Then, push the button. ...