CLUTCH SYSTEM > General Description
CAUTION
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Apply grease onto sliding or revolving surfaces before installation.
• Before installing O-rings or snap rings, apply sufficient amount of fluid to avoid damage and deformation.
• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth between the part and the vise.
• Keep fluid away from the vehicle body. If any fluid contacts the vehicle body, immediately flush the area with water.
Roof antenna (for Rod type)
CAUTION
Be sure to remove the antenna
rod before entering garages,
parking towers and other locations
with low ceilings.
Remove the antenna rod before
washing your car at a car wash. If
the antenna rod is left attached, it
may scratch the roof.
When reinstalling the removed
ant ...
Dtc c0057 ecm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0057 ECM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from ECM.Trouble symptom:• VDC does not operate.• EyeSight does not operate.STEPCHECKYESNO1.CHECK LAN SYSTEM.P ...
Dtc u1650 invalid data received from meter (uart)
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1650 INVALID DATA RECEIVED FROM METER (UART)DTC DETECTING CONDITION:There is an abnormality in UART data from combination meter.TROUBLE SYMPTOM:LCD is not displayed.WIRING DIAGRAM:Clearance Lig ...