Subaru Crosstrek Owners Manual: Casual speech recognization
Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command.
In some situations, it is possible to omit the command for the procedure and directly state the desired operation. Not all voice commands are displayed in the function menu.
NOTE
If the command cannot be recognized completely, the command input screen will be displayed. (Search results will be shown based on the part of the command that was recognized.)
Expression examples for each function
|
Command |
Command Expression examples |
| "Dial <phone number>" | Phone <phone number>. |
Voice command example: Dial
number
1. Press the talk switch on the steering
wheel.
2. Say "Dial number".
3. Say "Dial <number>".
For example, if the phone number is
2345678:
Say "two three four five six seven
eight"
...
Command list
Recognizable voice commands and their
actions are shown below.
NOTE
Some voice commands may not be
available depending on the market,
vehicle specifications or the device
connection status ...
Other materials:
Installation
WIPER AND WASHER SYSTEMS > Rear WasherINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Light assembly - high-mounted: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)Roof spoiler assembly: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)2. Check the nozzle - rear washer position. R ...
Control screen and audio panel
Select to display the audio source
selection screen.
Select to display the play mode
currently selected. Refer to "Select
play mode"
Select to display as a list (for the
models with AVRCP Ver. 1.4 or higher).
The track pauses when touched during
playback and plays when touched ...
Check power supply and ground line of engine control module (ecm)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureCHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM)CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspection Mode Inspection Mode > ...
