Subaru Crosstrek Owners Manual: Car settings
The items in the car settings can be set.
To change the items, operate the "
" or
" 
" switch, and then push the
button.
- Preparation for car settings
- Keyless buzzer volume setting
- Hazard warning flasher setting
- Defogger setting
- Interior light off delay timer setting
- Auto light sensor sensitivity setting
- Keyless access setting (models with "keyless access with pushbutton start system")
Driving history registration
The items in the driving history can be
registered. To change the items, operate
the " " or "
" switch, and then push the
button.
1. Turn the ignition switch to the "ON"
position.
...
Preparation for car settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to
show
the selection screen.
3. After the selection screen is displayed,
operate the " " or "
" switch to ...
Other materials:
Removal
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseREMOVAL1. NOZZLE - WINDSHIELD WASHER & HOSE1. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">2. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVAL">CAUTION:Before ...
Removal
LIGHTING SYSTEM > High-mounted Stop LightREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">3. Remove the light assembly - high-mounted.(1) Remove the nut.(2) From the inside of the r ...
Installation
DRIVE SHAFT SYSTEM > Propeller ShaftINSTALLATION1. Before installation, check the following items, and replace the propeller shaft assembly as necessary.• Dents or cracks on the tube surface• Splines for deformation or abnormal wear• Unsmooth joint operation or abnormal noise&bu ...
