It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position.
Type A combination meter
To change the setting, perform the following procedure.
1. Turn the ignition switch to the "LOCK"/ "OFF" or "ACC" position.
1) Trip knob
2. Press the trip knob to show " ON" or "OFF" on the trip meter display.
The display can be switched as shown in the following sequence by pressing the trip knob.
*: They cannot be displayed when the ignition switch is in the "ON" position.
To change the current setting, press the trip knob for at least 2 seconds.
ON - Activated
OFF - Deactivated
NOTE
Type B combination meter
Perform the procedures described in "Gauge Initial Movement" 3-41.
Speedometer
The speedometer shows the vehicle speed.
Safety precautions
WARNING
Always use the utmost care in
driving - overconfidence because
you are driving a vehicle with the
Vehicle Dynamics Control system
could easily lead to a serious accident.
CAUTION
Even if your vehicle is equipped
with Vehicle Dynamics Control
system, winter tires should be
used when ...
Preparation tool
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Selec ...
Operation
BODY CONTROL SYSTEM (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, selec ...