Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: BT Devices Connection screen

1. Press the HOME button.

2. Touch the "SETTINGS" key and then touch the tab.

3. Touch the "BT Devices Connection" key and then select the desired device to register.


"BT Devices Connection" screen (One device is registered.)

  1. Register the device. Refer to "Registering/ connecting Bluetoothdevice"
  2. Make the connection to the registered device.
  3. This shows the status of the device connection profile. (The icon illuminates while connected.)
  4. Delete the registered device. Refer to "Deleting a Bluetooth device"
  5. Switch to connect/disconnect Bluetooth communication. Refer to "Bluetooth ON/OFF"

Connecting a Bluetooth device

Up to 5 Bluetooth devices (phones and audio devices) can be registered.

If more than 1 Bluetooth device has been registered, select which device to connect to.

1. Display the "BT Devices Connection" screen. Refer to "BT Devices Connection screen" F5-68.

2. Select the device to be connected.

Supported profile icons will be displayed

Phone

Audio device

Smartphone Application

Supported profile icons for currently connected devices will illuminate

The audio icon illuminates only when in the Bluetooth audio mode.

All icons are dimmed when Bluetooth is set to off or when the connection cannot be made with the device.

NOTE

Bluetooth ON/OFF

  1. Display the "BT Devices Connection" screen. Refer to "BT Devices Connection screen"
  2. Select the "ON" or "OFF" key by the right side of the "Connect with Bluetooth" key. The "ON" key establishes a connection, and the "OFF" key disconnects the connection.

NOTE

The setting is fixed as the "OFF" key when no device is registered.

Deleting a Bluetooth device

1. Display the "BT Devices Connection" screen. Refer to "BT Devices Connection screen" F5-68.

2. Select the desired device.

3. Touch the   key for the device to be deleted, and then select the "OK" key.

NOTE

When deleting a Bluetooth phone, the contact data will be deleted at the same time.

Setting Bluetooth details
...

 In-Car-Device setting  screen
The Bluetooth settings can be confirmed and changed. 1. Display the "SETTINGS" screen. Refer to "Registering a Bluetooth phone for the first time" F5-65. 2. On the "SETTINGS" screen for "In- ...

Other materials:

Inspection
SECURITY AND LOCKS > Steering Lock CMINSPECTION1. Check if the steering lock is released when you start the engine using the push button ignition switch.2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS AC ...

Dtc p0965 pressure control solenoid "b" control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0965 PRESSURE CONTROL SOLENOID "B" CONTROL CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine speed increases abrup ...

Initial illumination for system check
When the ignition switch of the Subaru Ascent is turned to the "ON" position, multiple warning and indicator lights illuminate briefly and then turn off. This built-in self-check confirms that the systems and indicator bulbs are functioning correctly. To perform this system check, a ...

© 2016-2026 Copyright www.sucross.com