Subaru Crosstrek Owners Manual: BSD/RCTA approach indicator light/warning buzzer
While the BSD/RCTA is active, the following item(s) will operate to alert the driver:
- The BSD/RCTA approach indicator light (when there are vehicles in the neighboring lanes).
- The BSD/RCTA approach indicator light and warning buzzer (when a vehicle is approaching from the left or right side while your vehicle is reversing)
- BSD/RCTA approach indicator light
- Safety tips regarding the BSD/RCTA approach indicator light/warning buzzer
System operation
Operating conditions
The BSD/RCTA will operate when all of
the following conditions are met.
The ignition switch is in the "ON"
position.
The BSD/RCTA warning indicator and
BSD/RCTA OFF in ...
BSD/RCTA approach indicator light
BSD/RCTA approach indicator light
It is mounted on each side of the outside
mirrors.
The indicator light will illuminate when a
vehicle approaching from behind is detected.
The indicator ...
Other materials:
Dtc c0057 ecm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0057 ECM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from ECM.Trouble symptom:• VDC does not operate.• EyeSight does not operate.STEPCHECKYESNO1.CHECK LAN SYSTEM.P ...
Dtc u0416 invalid data received from vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEReceived error data from VDC CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROC ...
Dtc p0685 ecm/pcm power relay control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0685 ECM/PCM POWER RELAY CONTROL CIRCUIT/OPENDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
