Subaru Crosstrek Owners Manual: BSD/RCTA approach indicator light
BSD/RCTA approach indicator light
It is mounted on each side of the outside mirrors.
The indicator light will illuminate when a vehicle approaching from behind is detected.
The indicator light will flash to warn the driver of dangers under the following conditions.
- While the indicator light is illuminating, if the turn signal lever is operated toward the side in which this light turned on
- When reversing the vehicle while the system detects a vehicle approaching from either side
BSD/RCTA approach indicator light dimming function
When the headlights are turned on, the brightness of the BSD/RCTA approach indicator light will be reduced.
NOTE
You may have difficulty seeing the BSD/RCTA approach indicator light under the following conditions
- When sunlight shines directly on it
- When the headlight beams from a vehicle traveling behind shines directly on it
While the illumination brightness control dial is in the fully upward position, even if the headlights are turned on, the brightness of the BSD/ RCTA approach indicator light will not be reduced. For details about the illumination brightness control dial, refer to "Illumination brightness control" F3-92.
BSD/RCTA approach warning buzzer (only when reversing)
A warning buzzer sounds along with flashing of the BSD/RCTA approach indicator light to warn the driver of dangers.
The setting of the warning buzzer volume can be changed by operating the multi information display of the combination meter. For details, refer to "BSD/RCTA" F3-42.
BSD/RCTA approach indicator light/warning buzzer
While the BSD/RCTA is active, the following
item(s) will operate to alert the driver:
The BSD/RCTA approach indicator
light (when there are vehicles in the
neighboring lanes).
The BSD/RCTA ...
Safety tips regarding the BSD/RCTA approach indicator light/warning buzzer
In the following cases, operation of the
BSD/RCTA approach indicator light and
the warning buzzer may be delayed or the
system may fail to issue these warnings.
When a vehicle moves to the
ne ...
Other materials:
Using the jack
1. Park on a hard, level surface, whenever
possible, then stop the engine.
2. Apply the parking brake securely and
shift the shift lever in reverse (MT models)
or the select lever to the "P" (Park)
position (CVT models).
3. Turn on the hazard warning flasher
and unload all occupants and l ...
Rear center seating position
CAUTION
The head restraint is not intended to
be used at the retracted position.
Before sitting on the seat, raise the
head restraint to the extended position.
Incorrect (retracted position)
Correct (extended position)
To raise:
Pull the head restraint up.
To lower:
Push ...
Dtc b161a lost communication with front satellite sensor bus
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B161A LOST COMMUNICATION WITH FRONT SATELLITE SENSOR BUSDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Harness between airbag control module and front sub sensor is open or shorted.&bul ...