Braking tips
Two separate circuitsInstallation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSPECTION1. MANUAL A/C MODELWIRING DIAGRAM:1. Prepare the vehicle.NOTE:Check that the ambient temperature is 25 — 40°C (77 — 104°F) and that the humidity is 30% — 80%.• Place the vehicle in the workshop ...
Rear wiper
To turn the rear wiper on, turn the knob
switch upward.
To turn the wiper off, return the knob
switch to the " " position.
With the switch turned to the "
" position,
the rear wiper will operate intermittently
at intervals corresponding to the
vehicle speed. In this position, whe ...