Subaru Crosstrek Service Manual: Brake fluid

Installation

BRAKE > Brake BoosterINSTALLATION1. Check and adjust the operating rod of the vacuum booster assembly.(1) Measure the length between the vacuum booster assembly mounting surface and clevis pin hole ...

Inspection

BRAKE > Brake FluidINSPECTIONCAUTION:• Do not let brake fluid come into contact with the painted surface of the vehicle body. Wash away with water immediately and wipe off if it is spilled by ...

Other materials:

Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2270 O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...

Push button start system Wiring diagram
WIRING SYSTEM > Push Button Start SystemWIRING DIAGRAM ...

Removal
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorREMOVAL1. BATTERY CURRENT SENSORNOTE:Remove the battery current sensor and battery cable as a unit.1. Disconnect the battery ground cable and remove the clip from the battery rod.2. Remove the battery terminal boot.3. Remov ...