Subaru Crosstrek Service Manual: Blind spot detection/rear cross traffic alert (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0101 lost communication with tcm
- Dtc u0073 control module communication bus off
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc b2300 rear radar circuit low
- Dtc b2301 rear radar circuit high
- Dtc b2304 rear radar on-off switch stuck
- Dtc b2311 rear radar detect tcm
- Dtc b2313 rear radar detect vdc
- Dtc b2327 rear radar internal failure (internal electric circuit)
- Dtc b2329 rear radar axis alignment incomplete
- Dtc b2350 rear radar communication error between master and slave
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0402 invalid data received from tcm
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0422 invalid data received from body control module
- Dtc u0423 invalid data received from instrument panel cluster control module
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)
- Diagnostics with phenomenon Inspection
- Electrical component location Location
- Inspection mode Operation
- List of cancel code List
- List of diagnostic trouble code (dtc) List
- Read cancel code Operation
- Read diagnostic trouble code (dtc) Operation
Read diagnostic trouble code (dtc) Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target veh ...
Other materials:
Installation
SECURITY AND LOCKS > Front Outer HandleINSTALLATION1. Before installation, check the following items.• Rod is free from deformation.• Grease is applied sufficiently to rod joints.If grease is insufficient, add it as necessary before assembling the rod.• If the lever is faulty, r ...
Electrical specification
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. RADAR SENSORTerminal No.ContentMeasuring conditionStandardRadar sensor LH (master)Radar sensor RH (slave)1 ←> Chassis groundPrivate CAN HPrivate CAN HAlways1 M? or more2 &larr ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyASSEMBLY1. FORWARD CLUTCH ASSEMBLY1. Install the forward clutch piston to forward clutch drum.NOTE:• Apply CVTF to the seal of forward clutch piston.• Insert it all the way to the end.2. Install the return spring.3. In ...
