Subaru Crosstrek Owners Manual: Before driving
- Make certain that you and all of your passengers are wearing seatbelts.
- Carry some emergency equipment, such as a towing rope or chain, a shovel, wheel blocks, first aid kit and cell phone or citizens band radio.
- Secure all cargo carried inside the vehicle and make certain that it is not piled higher than the seatbacks. During sudden stops or jolts, unsecured cargo could be thrown around in the vehicle and cause injury. Do not pile heavy loads on the roof. Those loads raise the vehicle's center of gravity and make it more prone to tip over.
- Never equip your vehicle with tires larger than those specified in this manual.
Off road driving
WARNING
Always maintain a safe driving
speed according to the road and
weather conditions in order to
avoid having an accident on a
sharp turn, during sudden braking
or under other simil ...
During driving
General precautions:
Drive carefully. Do not take unnecessary
risks by driving in dangerous areas or
over rough terrain.
Slow down and employ extra caution at
all times. When driving off-r ...
Other materials:
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Disassembly
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof AssemblyDISASSEMBLY1. Remove the screw and remove the sunroof motor.2. Remove the stopper rubber and pull out the sunshade assembly from the rail assembly - sunroof.3. Disconnect the claws and then remove the drain holder.4. Remove the screw and p ...
Removal
LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector and remove the switch assembly - door. ...
