1. Perform the preparation steps according to "Preparation for image quality and volume settings"
2. Operate the " " or " " switch to select the "Beep" item. Then push the button.
3. Push the button.
4. Select an item by operating the " " or " " switch. Then push the button.
5. Select "Set" by operating the " " switch, and confirm the setting by pushing the button.
6. The system will notify you that the setting is complete.
Dtc u1235 lost communication with eyesight
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1235 LOST COMMUNICATION WITH EyeSightDTC DETECTING CONDITION:No data from stereo camera is received.TROUBLE SYMPTOM:Cooperation control of EyeSight does not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF ...
Synthetic oil
You should use synthetic engine oil that
meets the same requirements given for
conventional engine oil. When using
synthetic oil, you must use oil of the same
classification, viscosity and grade shown
in this Owner's Manual. Refer to "Engine
oil" F12-4. Also, you must follow the oil
and filte ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive PlateREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Set the ST.ST 498497300CRANKSHAFT STOPPER3. Remove the drive plate and reinforcement drive plate. ...