By operating " " or " " of the control switch, the screens and selection items can be switched. When the " /SET" switch is pulled toward you, the item can be selected and set.
If there are some useful messages, such as vehicle information, warning information, etc., they will interrupt the current screen, and appear on the display accompanied by a beep. If such a screen is displayed, take proper action according to the message shown on the screen.
The warning screen will return to the original screen after a few seconds. While the " " information reminder is shown on the display, it may be possible to display the warning screen again. To recall the message marked with " " on the display, pull the " /SET" switch on the steering wheel toward you.
Assembly
DRIVE SHAFT SYSTEM > Rear AxleASSEMBLY1. BUSHING - REAR AXLE HOUSINGDo not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.2. REAR BUSHING1. Before assembly, inspect the following items and replace any fau ...
Seatbelt safety tips
WARNING
All persons in the vehicle should
fasten their seatbelts BEFORE
the vehicle starts to move. Otherwise,
the possibility of serious
injury becomes greater in the
event of a sudden stop or accident.
All belts should fit snugly in order
to provide full restraint. Loose
fittin ...
Windshield washer fluid
Use windshield washer fluid. If windshield
washer fluid is unavailable use clean
water.
In areas where water freezes in winter,
use an anti-freeze type windshield washer
fluid. SUBARU Windshield Washer Fluid
contains 58.5% methyl alcohol and 41.5%
surfactant, by volume. Its freezing tempera ...