Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Basic diagnostic procedure Procedure

Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Basic Diagnostic Procedure

PROCEDURE

STEPCHECKYESNO

1.PERFORM CUSTOMER INTERVIEW.

Using the Check List for Interview, ask the customer the condition of how trouble occurs.

Did you interview the customer?

Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.

Interview the customer. Check List for Interview">

2.CHECK SUBARU SELECT MONITOR COMMUNICATION.

Check for communication with the radar sensor.

NOTE:

If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Subaru Select Monitor > INSPECTION">

Is communication possible?

Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.

Check the communication circuit.

3.CHECK RADAR SENSOR.

Read the DTC and cancel code of the radar sensors LH and RH using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)"> Read Cancel Code">

Is DTC displayed?

Perform the diagnosis according to DTC and cancel code. (Perform the diagnosis to the side that displayed the DTC.) List of Diagnostic Trouble Code (DTC)"> Read Cancel Code">

After diagnosis, Basic Diagnostic Procedure > PROCEDURE">Go to Step 6.

Basic Diagnostic Procedure > PROCEDURE">Go to Step 4.

4.PERFORM DIAGNOSTICS WITH PHENOMENON.

Check the list of Diagnostics with Phenomenon. Diagnostics with Phenomenon">

Does the symptom apply?

Perform diagnosis according to the procedures in the diagnostics with phenomenon.

Basic Diagnostic Procedure > PROCEDURE">Go to Step 5.

5.CHECK TROUBLE PHENOMENON.

1) Perform the basic inspection. General Description > INSPECTION">

2) Check the radar sensor. Control Module I/O Signal">

3) Perform check of current data. Read Current Data">

Was the trouble cause found?

Perform the Clear Memory after repairing or replacing the cause of trouble.

System is normal.

6.PERFORM DIAGNOSIS.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Perform the Inspection Mode. Inspection Mode">

Is DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Finish the diagnosis.

Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > System Operation Check ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target ...

Check list for interview Check
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for in ...

Other materials:

Fuses
CAUTION Never replace a fuse with one having a higher rating or with material other than a fuse because serious damage or a fire could result. The fuses are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. The fuses are located in two fuse ...

Conditions in which front passenger's SRS frontal airbag is activated
The Subaru Ascent is equipped with an intelligent SRS frontal airbag system that activates based on real-time analysis of the front passenger seat conditions. The front passenger's SRS frontal airbag is designed to deploy during an impact when specific criteria are met, ensuring optimal sa ...

Dtc u0164 lost communication with hvac control module
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0164 LOST COMMUNICATION WITH HVAC CONTROL MODULEDetected when CAN data is not received from A/C CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

© 2016-2026 Copyright www.sucross.com