Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Basic diagnostic procedure Procedure

Subaru Crosstrek Service Manual / Airbag system (diagnostics) / Basic diagnostic procedure Procedure

AIRBAG SYSTEM (DIAGNOSTICS) > Basic Diagnostic Procedure

PROCEDURE

STEPCHECKYESNO

1.CHECK WARNING LIGHT.

Check whether the airbag warning light in the combination meter is lit.

Does the airbag warning light illuminate?

Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.

Perform the diagnosis according to phenomenon of the problem.

2.READ DTC.

1) Turn the ignition switch to OFF.

2) Connect the Subaru Select Monitor to data link connector.

3) Turn the ignition switch to ON and run the Subaru Select Monitor.

4) Read the DTC. (Current malfunction) Read Diagnostic Trouble Code (DTC)">

NOTE:

If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Subaru Select Monitor > INSPECTION">

5) Record all DTCs, time stamp and freeze frame data.

NOTE:

For time stamp, refer to “LAN SYSTEM”. General Description > CAUTION">

Are any DTCs displayed?

Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.

Go to “Airbag Warning Light Failure” Airbag Warning Light Failure">.

3.PERFORM DIAGNOSIS.

1) Determine the possible cause from “List of Diagnostic Trouble Code (DTC)” List of Diagnostic Trouble Code (DTC)">.

2) Inspect the DTC using “List of Diagnostic Trouble Code (DTC)”.

3) Repair the trouble cause.

4) Perform the Clear Memory Mode. Clear Memory Mode">

5) Perform the Inspection Mode. Inspection Mode">

6) Read any other DTCs displayed. Read Diagnostic Trouble Code (DTC)">

Are any DTCs displayed?

Perform the procedure 1) to 5) in step 3.

Finish the diagnosis.

Airbag warning light illumination pattern Inspection
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination PatternINSPECTIONTurn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 seconds then turn ...

Batch save of event record data Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Batch save of Event record dataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and sel ...

Other materials:

Electronic Brake Force Distribution (EBD) system
The EBD system maximizes the effectiveness of the brakes by allowing the rear brakes to supply a greater proportion of the braking force. It functions by adjusting the distribution of braking force to the rear wheels in accordance with the vehicle's loading condition and speed. The EBD syst ...

Profiles
This system supports the following services. NOTE If your cell phone does not support HFP, registering the Bluetooth phone or using OPP, PBAP, or SPP profiles individually will not be possible. If the connected Bluetooth device version is older than recommended or incompatible, the ...

11
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code11When CRUISE switch is pressed, or a malfunction related to CRUISE switch occurs, this is detected.Trouble symptom:• Cruise control cannot be set. (Cancelled immediately.)• Cruise control cannot be released.Wi ...

© 2016-2026 Copyright www.sucross.com