TELEMATICS SYSTEM (DIAGNOSTICS) > Basic Diagnostic Procedure
PROCEDURE
| STEP | CHECK | YES | NO |
1.PERFORM CUSTOMER INTERVIEW.
Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Check List for Interview > CHECK">
Did you interview the customer?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
Interview the customer. Check List for Interview > CHECK">
2.CHECK SUBARU SELECT MONITOR COMMUNICATION.
Using the Subaru Select Monitor, check whether communication to the telematics system can be executed.
NOTE:
If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. (Refer to "Communication for initializing impossible".) Subaru Select Monitor > INSPECTION">
Is communication possible?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.
Check the communication circuit.
3.CHECK TELEMATICS.
Using the Subaru Select Monitor, read DTC of the telematics system. Diagnostic Code(s) Display > OPERATION">
NOTE:
If DTC is detected, only RED LED will illuminate. For details, refer to "LED operation status list". Check List for Interview > CHECK">
Is DTC displayed?
Perform the diagnosis for the displayed DTCs. Diagnostic Code(s) Display > LIST">
Basic Diagnostic Procedure > PROCEDURE">Go to Step 4.
4.CHECK DIAGNOSTICS WITH PHENOMENON.
Check the list of Diagnostics with Phenomenon. Diagnostics with Phenomenon">
Does the symptom apply?
Perform diagnosis according to the procedures in the diagnostics with phenomenon.
Basic Diagnostic Procedure > PROCEDURE">Go to Step 5.
5.CHECK TROUBLE PHENOMENON.
1) Perform the basic inspection and function check. General Description > INSPECTION">
2) Check the data communication module. Control Module I/O Signal">
3) Perform check of current data. Read Current Data">
4) Perform a unit check.
Was the trouble cause found?
Perform the Clear Memory after repairing or replacing the cause of trouble. Clear Memory Mode">
System is normal.
Operation
Check list for interview CheckDisassembly
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxDISASSEMBLYCAUTION:• Nut for fixing the rack is on the driver’s side only. When removing the tie-rod on the passenger’s side, turn over the boot - steering gearbox on the driver’s side, and fix the rac ...
Dtc u0327 software incompatibility with vehicle security control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0327 SOFTWARE INCOMPATIBILITY WITH VEHICLE SECURITY CONTROL MODULEDTC DETECTING CONDITION:No data is received from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operate proper ...
Wiring diagram
SECURITY AND LOCKS > Security SystemWIRING DIAGRAMRefer to “Security System” in the wiring diagram.• Model without push button start: Security System > WIRING DIAGRAM">• Model with push button start: Security System > WIRING DIAGRAM"> ...