OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Basic Diagnostic Procedure
PROCEDURE
STEP | CHECK | YES | NO |
1.CHECK WARNING LIGHT.
Check whether the airbag warning light in the combination meter is lit.
Does the airbag warning light illuminate?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
Perform the diagnosis according to phenomenon of the problem.
2.READ DTC.
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to data link connector.
3) Turn the ignition switch to ON and run the Subaru Select Monitor.
4) Read the DTC. Read Diagnostic Trouble Code (DTC) > OPERATION">
NOTE:
If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Subaru Select Monitor > INSPECTION">
5) Record all DTCs and freeze frame data.
Is DTC displayed?
Basic Diagnostic Procedure > PROCEDURE">Go to Step 3.
Go to “Airbag Warning Light Failure” Airbag Warning Light Failure">.
3.PERFORM DIAGNOSIS.
1) Determine the possible cause from “List of Diagnostic Trouble Code (DTC)” List of Diagnostic Trouble Code (DTC)">.
2) Inspect the DTC using “List of Diagnostic Trouble Code (DTC)”.
3) Repair the trouble cause.
4) Perform the Clear Memory Mode. Clear Memory Mode">
5) Perform the Inspection Mode. Inspection Mode">
6) Read any other DTCs displayed.
Is DTC displayed?
Perform the procedure 1) to 5) in step 3.
Finish the diagnosis.
Dtc b16f3 front sub sensor lh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F3 FRONT SUB SENSOR LH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:Front sub sensor (LH) is misinstalled.CAUTION:Before performing diagnosis, refer to “CAUTION&rdqu ...
Casual speech recognization
Due to natural language speech recognition
technology, this system enables recognition
of a command when spoken
naturally. However, the system cannot
recognize every variation of each command.
In some situations, it is possible to
omit the command for the procedure and
directly state the de ...
Control screen and audio panel
Select to display the audio source
selection screen.
Select to display the play mode
currently selected. Refer to "Select
play mode"
Select to display iPod List. Refer to
"iPod settings"
Shows progress.
Turn to adjust volume.
Press to turn the audio system on/off.
Turn to ...