HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Basic Diagnostic Procedure
PROCEDURE
NOTE:
When the sunload sensor check is performed indoors or in the shade, it could be diagnosed as sensor having an open circuit. Always perform the inspection in direct sunlight.
STEP | CHECK | YES | NO |
1.START INSPECTIONS.
1) Prepare the tools. General Description > PREPARATION TOOL">
2) Perform the pre-inspection. General Description > INSPECTION">
Is any malfunction found in pre-inspection?
Fix the malfunction found in pre-inspection, and go to the next inspection step. Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
2.CHECK DTC.
1) Under the failure condition, leave the vehicle for one minute or more.
2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
NOTE:
• If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Diagnostic Procedure for Subaru Select Monitor Communication > COMMUNICATION FOR INITIALIZING IMPOSSIBLE">
• Record the time stamp and the freeze frame data recorded together with the DTC. For time stamp, refer to “LAN SYSTEM”. General Description > CAUTION">
Is DTC displayed?
List of Diagnostic Trouble Code (DTC) > LIST">
Refer to Diagnostics with Phenomenon. Diagnostics with Phenomenon > INSPECTION">
Installation
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSTALLATION1. Replace the rear differential side oil seal. Rear Differential Side Oil Seal > REPLACEMENT">NOTE:After pulling out the drive shaft assembly, be sure to replace with a new oil seal.2. Insert the drive shaft assembly into the rear hub ...
Installation
MECHANICAL(H4DO) > V-beltINSTALLATION1. V-BELTInstall in the reverse order of removal.CAUTION:• When reusing the V-belt, wipe off dust and water with cloth.• Do not use the V-belt if there is any oil, grease or coolant on the belt.• Be careful not to rub the V-belt end surface w ...
General diagnostic table Inspection
BODY CONTROL SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONRead the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)"> Or check the following data under the current data display screen. Read Current Data">ItemOperationSpecificationsNoteYESNODiagnost ...