Subaru Crosstrek Owners Manual: Automatic engine shutdown
The remote engine start system will automatically shut down or will not start the engine under the following conditions.
- The total run-time has exceeded 20 minutes.
- Any door or the rear gate is opened.
- The select lever is moved to any position other than "P".
- The engine hood is opened.
- The push-button ignition switch is pressed.
- The brake pedal is depressed.
- The engine speed is 3,000 rpm or more.
The time until the engine automatically stops differs according to the setting.
To change the time until the engine automatically stops, contact your SUBARU dealer. However, local laws and regulations may prohibit changing this time.
When starting the engine
To start the engine with remote engine
start system, briefly press the lock button
twice within 2 seconds, then press and
hold the lock button for 3 seconds.
1. Press the lock button briefly. Th ...
Models without "keyless access with push-button start system"
Remote engine starter transceiver (fob)
Fob button
...
Other materials:
Manual transmission oil
It is not necessary to check the transmission
oil level. Check that there are no
cracks, damage or leakage. However, the
oil inspection should be performed according
to the maintenance schedule in
the "Warranty and Maintenance Booklet".
Consult your SUBARU dealer for details.
Recommended gr ...
Basic inspection
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC INSPECTION1. VOLTAGE MEASUREMENT1. Using a voltmeter, connect the negative lead to a good ground point or negative battery terminal and the positive lead to the connector or component terminal.2. Contact the positive lead of the voltmeter on connect ...
Dtc u0073 control module communication bus off
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFNOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as N ...
