Subaru Crosstrek Service Manual: Auto headlight beam leveler system (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc b2903 vdc data error
- Dtc u0140 lost communication with body control module
- Dtc b2900 ahl control
- Dtc b2902 rear height sensor circuit
- Dtc u0073 control module communication bus off
- General description
- Read current data
- Subaru select monitor
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Diagnostics with phenomenon Inspection
- Electrical component location Location
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
Inspection locations after a collision Inspection
AIRBAG SYSTEM > Inspection Locations after a CollisionINSPECTIONIf the vehicle is involved in a collision, even if it is a slight collision, be sure to check the following systems.1. DRIVER’S ...
Other materials:
Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.Install in the reverse order of removal.NOTE:• Use new O-rings.&bul ...
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...