Subaru Crosstrek Service Manual: At shift lock solenoid and p range switch

Wiring diagram

CONTROL SYSTEMS > AT Shift Lock Control SystemWIRING DIAGRAM1. MODEL WITHOUT PUSH BUTTON IGNITION SWITCH(1)Ignition switch(5)TCM (shift range information)(9)Battery(2)Stop light and brake switch(6) ...

Inspection

CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range SwitchINSPECTIONSTEPCHECKYESNO1.CHECK SOLENOID UNIT.Measure the resistance of solenoid unit connector terminals.TerminalsNo. 4 — ...

Other materials:

Removal
REAR SUSPENSION > Rear Shock AbsorberREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the sensor assembly - headlight beam leveler. (Model with auto headlight beam leveler, left side only)CAUTION ...

Assembly
CLUTCH SYSTEM > Operating CylinderASSEMBLYNOTE:During assembly, apply hydraulic oil to all parts.Recommended brake fluid:New FMVSS No. 116 DOT3 or DOT41. Install the piston spring.2. Insert piston into the operating cylinder.3. Install push rod to the boot.4. Install the boot and push rod. ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor PlateINSTALLATIONThe crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for installation procedure. Drive Plate > INST ...