Subaru Crosstrek Service Manual: Assembly
WIPER AND WASHER SYSTEMS > Wiper Blade
ASSEMBLY
1. FRONT
1. Insert the rubber assembly - windshield wiper onto the blade - windshield wiper so that the stopper is in the position shown in the figure.
2. Make sure the rubber assembly - windshield wiper is securely fastened to the pull stopper (a).
2. REAR
1. Insert the rubber assembly - rear wiper into claw (B).
2. Insert the rubber assembly - rear wiper until its top end protrudes approx. 20 mm (0.79 in) from stopper (D).
3. Insert the rubber assembly - rear wiper into claw (A).
Wiper blade
...
Removal
WIPER AND WASHER SYSTEMS > Wiper BladeREMOVAL1. FRONTWhile pushing the locking clip (A) up, pull out the blade assembly - windshield wiper in the direction of the arrow, and remove it from the arm ...
Other materials:
Dtc u1235 lost communication with eyesight
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1235 LOST COMMUNICATION WITH EyeSightDTC DETECTING CONDITION:No data from stereo camera is received.TROUBLE SYMPTOM:Cooperation control of EyeSight does not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF ...
Navigation system Wiring diagram
WIRING SYSTEM > Navigation SystemWIRING DIAGRAM1. WITHOUT TELEMATICS2. WITH TELEMATICS ...
Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the latch and actuator - rear gate.(1) Disconnect the connector.(2) Remove the bolts, ...
