Subaru Crosstrek Service Manual: Assembly
REAR SUSPENSION > Rear Shock Absorber
ASSEMBLY
1. Before assembly, check each part. Rear Shock Absorber > INSPECTION">
2. Using a coil spring compressor, compress the coil spring - rear.
CAUTION:
When installing the coil spring compressor to the coil spring, follow the operation manual accompanied with the coil spring compressor during operation.
3. Install by aligning with the edge surface of the coil spring - rear and the stopper portion of the lower side spring seat.
(a) | Coil spring - rear |
(b) | 0+ 10 mm (0 + 0.4 in) |
(c) | Spring seat stopper portion |
4. Install the helper - rear and the dust cover - rear shock to the piston rod.
5. Fully pull up the piston rod in the upward direction.
6. Temporarily tighten the rubber seat - shock UPR and the shock mount - rear with new self-locking nuts.
NOTE:
Position the shock mount - rear as shown in the figure.
A | LH side |
B | RH side |
(a) | Front side of vehicle |
(b) | Vehicle outside |
(c) | 0°±10° |
(d) | End portion of coil spring - rear |
7. Using a hexagon wrench to prevent the shock absorber piston rod from turning, tighten the new self-locking nut with ST.
CAUTION:
Make sure that the shock mount - rear turns smoothly after tightening.
Preparation tool:
ST: STRUT MOUNT SOCKET (20399FG000)
Tightening torque:
25 N·m (2.55 kgf-m, 18.4 ft-lb)
8. Loosen the coil spring compressor carefully.
Removal
REAR SUSPENSION > Rear Shock AbsorberREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the senso ...
Other materials:
Airbag warning light remains on
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Warning Light FailureAIRBAG WARNING LIGHT REMAINS ONDetecting condition:• Airbag warning light is faulty.• Airbag control module to combination meter circuit is shorted or open.• Grounding circuit is faulty.• Airbag control module is fa ...
Dtc p0967 pressure control solenoid "b" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0967 PRESSURE CONTROL SOLENOID "B" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Engine speed increases abruptly, and can not star ...
Dtc p050a cold start idle control system performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P050A COLD START IDLE CONTROL SYSTEM PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine keeps running at higher speed than specified ...
