Subaru Crosstrek Service Manual: Assembly

1. Install the fuel pipe and cap to the intake manifold.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the fuel delivery pipe to the intake manifold.

CAUTION:

• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.

• When connecting the quick connector, make sure to insert it all the way in before locking the slider.

• When it is difficult to lock the slider, check that the connector is fully inserted.

• After locking the slider, check again that the quick connector is securely connected.

Connect the quick connector as shown in the figure.

3. Temporarily install the EGR pipe to the intake manifold.

NOTE:

• Use a new gasket.

• Tighten the EGR pipe when installing the intake manifold.

4. Install the manifold absolute pressure sensor. Manifold Absolute Pressure Sensor > INSTALLATION">

5. Install the purge control solenoid valve. Purge Control Solenoid Valve > INSTALLATION">

6. Install the throttle body. Throttle Body > INSTALLATION">

Intake manifold

Removal

Other materials:

Disassembly
EXTERIOR/INTERIOR TRIM > Door TrimDISASSEMBLY1. Remove the door trim.2. Remove the rivets and claws, and remove the weather strip - door INN from the door trim.(a)Rivet(b)Claw(c)ClawNOTE:Remove the rivets by using the rivet cutter or nippers. ...

Refueling in cold weather
To help prevent moisture from forming in the fuel system and the risk of its freezing, use of an antifreeze additive in the fuel tank is recommended during cold weather. Use only additives that are specifically designed for this purpose. When an antifreeze additive is used, its effect lasts ...

Dtc p0196 engine oil temperature sensor "a" range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0196 ENGINE OIL TEMPERATURE SENSOR "A" RANGE/PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start• Improper id ...