EXTERIOR/INTERIOR TRIM > Door Trim
ASSEMBLY
1. Bend the claws while pushing the weather strip - door INN against the door trim so that there is no gap.
CAUTION:
Beware of the direction of folding the claws.
(a) | Rivet | (b) | Direction of folding claws | (c) | Claw bending direction: bend forward for LH side, backward for RH side. |
2. Install the rivet.
CAUTION:
• Set the height of rivet crimped section as 3 mm (0.12 in). If the crimp is not sufficient, press it with pliers, etc. in order not to interfere the trim panel - door.
• Apply unwoven cloth tape so that the rivet crimped section is covered. If unwoven cloth tape is not applied, a knocking noise may occur when the door panel contacts the rivet crimped section.
Preparation tool and item:
Hand riveter (corresponding to φ3.2 mm (0.13 in))
Rivet
Tape: 94029FG000/TAPE or unwoven cloth
3. After installing the weather strip - door INN, perform the following checks.
• Make sure there are no gaps between the weather strip - door INN and the door trim.
• Make sure there are no looseness when pulling the weather strip - door INN lightly.
Climate control panel, audio panel, instrument panel, console panel, and
switches
Use a soft, damp cloth to clean the climate
control panel, audio equipment, instrument
panel, center console, combination
meter panel, and switches.
CAUTION
Do not use organic solvents such
as paint thinners or fuel, or
strong cleaning agents that contain
those solvents. Doing so
cou ...
Installation
REAR SUSPENSION > Rear Sub FrameINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.• Install so that the front end of the under cover (b) com ...
Installation
MECHANICAL(H4DO) > Cam CarrierINSTALLATION1. CAM CARRIER RH1. Insert the steel rods into ST, and set the engine so that the camshaft RH is facing up.CAUTION:• If the engine is standing on one side without inserting the steel rod into ST, engine may lose balance and fall down. Be sure to ins ...