EXHAUST(H4DO) > Front Exhaust Pipe
ASSEMBLY
1. Install each cover to the front exhaust pipe.
Tightening torque:
13 N·m (1.3 kgf-m, 9.6 ft-lb)
(A) | Front exhaust pipe upper cover | (E) | Front catalytic converter lower cover LH | (H) | Front exhaust pipe side cover LH (rear) |
(B) | Front catalytic converter upper cover LH | (F) | Front exhaust pipe lower cover | (I) | Front exhaust pipe side cover RH (front) |
(C) | Front catalytic converter upper cover RH | (G) | Front exhaust pipe side cover LH (front) | (J) | Front exhaust pipe side cover RH (rear) |
(D) | Front catalytic converter lower cover RH |
2. Install the center exhaust pipe to front exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
42.5 N·m (4.3 kgf-m, 31.3 ft-lb)
3. Install the front oxygen (A/F) sensor and rear oxygen sensor to the front exhaust pipe. Front Oxygen (A/F) Sensor > INSTALLATION"> Rear Oxygen Sensor > INSTALLATION">
Rear wiper
To turn the rear wiper on, turn the knob
switch upward.
To turn the wiper off, return the knob
switch to the " " position.
With the switch turned to the "
" position,
the rear wiper will operate intermittently
at intervals corresponding to the
vehicle speed. In this position, whe ...
Disassembly
CONTROL SYSTEMS > Select LeverDISASSEMBLY1. GRIP ASSY1. Remove the button assembly_AT.(A)Claw2. Remove the rod COMPL.2. AT SELECT LEVER ASSEMBLY1. Remove the spacer plate.2. Remove the gasket.3. Insert a flat tip screwdriver with a thin tip under the connector and disconnect the harness connector ...
Regarding setting
NOTE
The operational/non-operational
setting for the keyless access function
can be changed. For the setting procedure,
refer to "Disabling keyless access
function" 2-17. The setting can
also be changed by a SUBARU dealer.
For more details, contact a SUBARU
dealer.
For detailed ...